![]() Squeeze the potential of this post processing function to obtain nice flat-bottom solid meshes. Use the Cutting Plane Tool to rapidly cut and align any mesh to the CSYS. It will be orientated in the CSYS according to the Cutting Plane Tool. The plane will align the mesh to the XY plane: Finally, click on Orient Based On Plane to use the cutting plane as origin for the CSYS.In the example, we selected Delete the selection and close intersection to obtain a flat-bottom solid mesh. The resulting mesh is a Unwatertight (surface) mesh. Delete the selection: it deletes the highlighted (red) data. The resulting mesh is a Watertight (solid) mesh. Eventually you obtain a flat-filled hole. Delete the selection and close intersection: it deletes the highlighted (red) data and will close the mesh using the cutting plane. Once the cutting plane is located, click on Intersect Plane. Select whether to Delete the selection and close intersection or simply Delete the selection:.To ensure that we place the cutting plane at the desired position, we will firstly make sure that the Orthogonal view is enabled:Īt this point we can orientate the mesh as desired and draw the straight line holding SHIFT + LMB. Note the background may look strange look for the small rectangle in the upper right and click this to make the window appear with the white bar at the top. With the default 3D cockpit view selected, click on the virtual GNS530 screen so that it pops out. The software will ask to define a cutting plane using a straight line. Start X-Plane and load the default Cessna 172SP.In this example we are post processing a mesh from a scan applying the Watertight settings: Move to the Post Processing tab and load a mesh or mesh a project.Use the plane to align the mesh to the CSYS.Use the plane to cut the mesh and close it at the intersection. ![]() This tool allows defining a plane by drawing a straight line.In the program, users have the option of performing either DETERMINISTIC or PROBABILISTIC analyses. ROCPLANE analyzes a slice of unit thickness taken perpendicular to the strike of the slope face. The Cutting Plane Tool is located under the Post Processing tab, since it is used to operate meshes. A planar wedge is a wedge for which sliding occurs on a plane approximately parallel to the face of a slope. It can be used to cut a mesh using a plane and to rapidly align it to the Coordinate System (CSYS). The Cutting Plane Tool is a very powerful editing tool which located in the Post Processing tab. This article was written based on EXScan HX v1.3.0.3 software
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |